Ss-cycle Replacing Data Link Connector Plug Used In SSW+ Ig Manual do Utilizador descarregar pdf

Early shipments of S&S part #55-1050 SSW+ Ignition Installation Kit were shipped with a rubber data port connector

plug that does not insulate sufficiently, allowing a slight electric current flow between the connector pins. The original

plug could cause the ignition to use more electricity than normal, and could also cause the MIL (Malfunction Indicator

Lamp) to flash in an erratic fashion.

See

Picture 1 to identify data port connector and plug. If the installation kit has a rubber data plug with no part number

on it, it should be discarded and replaced with a new plug. The correct replacement plug supplied by S&S will have

either #55-1022-S, or #72164-94 molded into the plug.

A replacement plug can be obtained from S&S by calling the Technical Department at 608-627-8324.

Service Bulletin #51-1159

2-27-03

by S&S Cycle, Inc.

Because every industry has a leader

S Cycle, Inc.

14025 County Highway G Box 215

Viola, Wisconsin 54664

Phone: 608-627-2080 • Fax: 608-627-1488

Technical Service Phone: 608-627-TECH (8324)

Technical Service Email: [email protected]

Website: www.sscycle.com

Replacing Data Link Connector Plug

Used In SSW+ Ignition Installation Kit #55-1050

S&S Service Bulletin

Picture 1

Early shipments of S&S part #55-1050 SSW+ Ignition Installation Kit were shipped with a rubber data port connectorplug that does not insulate suff

Sem comentários

Ss-cycle Replacing Data Link Connector Plug Used In SSW+ Ig Manual do Utilizador